Bearing pullers, separators, fitting tools and hook spanners
Two-jaw and three-jaw pullers, bearing separators, a bearing fitting tool kit with impact rings and sleeves, an induction bearing heater, and hook spanners for KM lock nuts.
Mounting and dismounting without damage
Always apply the force to the ring that has the tight fit, the inner ring on a shaft or the outer ring in a housing, and never through the balls or rollers. A three-jaw puller centres itself and spreads the load; a separator is used when the jaws cannot grip behind the bearing. Heating a bearing to about 110 degrees C lets it slide onto the shaft without force; never heat it above 125 degrees C.